Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-26-2003, 08:22 AM
|
#3 |
|
Registered Member
Join Date: Feb 2003
Location: Minturn, CO 81645
Posts: 109
|
stalling engine
The engine will not turn over unless I pull the middle wire on the distributor and let it ark. The engine doesn't want to run unless you floor it and then it will shut down. The ECT is brand new. I tested it by measuring accross both terminals and received 2 volts. With the sensor connected and koeo I back probed through the wiring harness and found the same results.
I cleared the codes and try to run a KOER test and the scanner says that I'm not able to keep the engine running. One day I drove the car around and was able to get a lot of KOEO codes. I will post to night. PKRWUD thankx for your help. I am clueless and really need your help.  |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ignition problem again | 289 | Windsor Power | 0 | 01-08-2004 09:24 AM |
| Ignition and Idling problem still | 1995gtStang | Windsor Power | 3 | 07-26-2003 08:11 AM |
| Ignition Problem, hopefully simple | QUIN | Windsor Power | 3 | 05-09-2002 03:43 PM |
| Ignition problem. | Pongo | Windsor Power | 1 | 04-26-2002 08:41 PM |
| headlights on the fritz, also ignition key cylinder problem | fiveohpatrol | Windsor Power | 1 | 04-12-2002 02:03 AM |