Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-26-2003, 09:20 AM
|
#3 |
|
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
Well, in part I am referring to the air inlet tube. Like I said, I made a custom in-fender intake, but it's made out of thin aluminum. What I need to find for it is some 4 in. insulation. Home Depot, Lowes, etc. around here doesn't seem to have any insulation wrap bigger than 2 inches.
But the main piece I'm talking about actually wraps OVER and AROUND the upper intake manifold. Like I said, I KNOW it exists SOMEWHERE because I've seen someone's car with one of them. Maybe it was custom, I don't know. But it looked like it was made to fit and just slipped over.
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.6L Intake spacer!!!! | skz4u | Modular Madness | 18 | 01-27-2003 11:11 PM |
| cobra upper and lower intake | scale | Windsor Power | 1 | 01-16-2003 03:25 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |
| upper intake plenum volume? | mikos chris | Windsor Power | 1 | 01-04-2001 03:50 AM |