Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-27-2003, 07:59 PM
|
#1 |
|
Registered Member
Join Date: Feb 1999
Location: Altoona, PA
Posts: 31
|
....and going, and going...
I just stumbled across this thread and thought I would add to it.
I'm still using that same clutch. I'm talking about the one that was already 2yrs old in my previous post. It hasn't seen any slick launches since August, 2000 when I got 8 runs in, but I have since installed drag launch springs and struts and abuse it on a daily basis. The clutch held better than the mainshaft in my tranny. It twisted in half right in front of 3rd gear (looked like a machine cut - it was so perfect). John
__________________
Altoona, PA 1993 GT, full MAC exhaust, 3.73, ported stock heads, E-303, Trick Flow Street intake, 65mm TB, 75mm Bullet, 24lb injectors. MAC upper/lower control arms, Motorsport aluminum driveshaft, BBK subframes welded in, Comp Engineering adjustable drag shocks Best E.T. on wasted slicks: 13.300 @ 102.49 w/1.84 60' No times yet on these new parts: Eibach drag launch kit, Lakewood 90/10 struts. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| KING COBRA CLUTCH-any good? | 429mustang | Blue Oval Lounge | 2 | 10-03-2002 09:40 AM |
| 98 Cobra clutch question | wally6761 | Modular Madness | 0 | 03-12-2002 04:23 PM |
| Got in Several races with a 99, or 01 Cobra Vert. | Mercury | Stang Stories | 3 | 11-25-2001 03:20 PM |
| Installing Tremec 3550 & King Cobra clutch - Any tips? | 302 LX Eric | Windsor Power | 1 | 09-05-2001 09:48 PM |