Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-28-2001, 01:58 PM
|
#8 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
A die grinder with a cut-off wheel will do wonders for cutting the springs. I can't remember if it's a half coil or a full coil you are supposed to cut off of the C's, but there is a sheet of paper in the box that tells you.
------------------ Gunning for 12's!  Buy your parts here ICQ# 42269241 [This message has been edited by 2FastLX (edited 07-28-2001).] |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| stocks springs vs. lowering springs | GhettoPop | Windsor Power | 1 | 02-12-2004 07:08 PM |
| can I use hardtop springs in my vert? | tireburner163 | Windsor Power | 5 | 02-25-2003 02:46 PM |
| H&R springs or Eibach?? (replaing my Jamex Springs) | KB94GT | Modular Madness | 0 | 05-14-2002 07:44 PM |
| valve springs....questions | Old Guy with 87 GT | Windsor Power | 5 | 05-03-2002 06:36 AM |
| Springs | MDM | Windsor Power | 0 | 04-11-2001 06:53 PM |