MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 06-07-2003, 10:07 PM   #2
Mountain Main
Registered Member
 
Join Date: Feb 2003
Location: Minturn, CO 81645
Posts: 109
Default I Reran KOEO

I let the engine warm up and turned the key off and disconnected the negative cable to the battery. I came back in ten minuetes and took the car for a drive. I drove it for a half an hour. I even brought the car up to ninty miles an hour. I received no check engine light. I then pulled into my driveway and ran a KOEO Test

I received these codes. Here they are in order

67 Neutral Drive Switch (NDS) circuit open; A/C input high
67 Neutral Drive Switch (NDS) circuit open; A/C input high
22 Map/BP [BARO*] out of Self Test Range
34 In sufficient EGR flow/Excessive exhaust back pressure; or EVP above closed limit (sonic) / PFE sensor voltage high or out-of-range
51 ECT sensor fault or open circuit
53 TP circuit above maximum voltage
54 ACT [IAT*] or VAT sensor fault, circuit open
22 Map/BP [BARO] out of Self Test Range
34 In sufficient EGR flow/Excessive exhaust back pressure; or EVP above closed limit (sonic) / PFE Sensor voltage high or out-of-range
51 ECT sensor faut of open circuit
53 TP circuit above maximum voltage
54 ACT {IAT*] or VAT sensor fault, circuit open

I think I am going to check out the ECT sensor and check for OHMs in the wiring harness.

Any comments thankx

Mountain Main
Mountain Main is offline   Reply With Quote
 



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Pulled codes...what do they mean? Hethj7 Windsor Power 8 06-12-2003 12:03 PM
Pulled intake and swapped fuel rails now getting codes. Rebel79 Windsor Power 3 09-03-2002 12:13 AM
pulled codes and could use some advice Conman Windsor Power 9 08-17-2002 06:41 PM
Pulled codes today... bobtodd Windsor Power 24 08-08-2002 07:55 PM
Pulled Codes from Car, Need Help! StreetStang37 Windsor Power 11 09-24-2001 05:58 AM


All times are GMT -5. The time now is 05:26 PM.


SEARCH