Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-14-2003, 10:03 AM
|
#4 |
|
Registered Member
Join Date: Oct 1998
Location: Az
Posts: 854
|
a little..the stock 4v carn is around 570 cfm.. I think..
none of them are going to bolt up without fuel line mods... but I think you could swap the bowls off the stock carb to the new one... then it would be pretty much the same.. if you get a 600, get the quick change secondary spring kit and put a lighter spring in so the secondaries open quicker.. for that matter, you could put it on the stock carb, and see if it helps.. then move it to the new carb later :-)
__________________
84 convt,roller 302,AFR's, performer 3.55's, underdrives BBK shorties stock cam, 1.7's 13.58@102.84 and a '68 stang .. project 8 sec street car... 557 big block + N20 :-) http://members.cox.net/darkknight302/68nwrear.jpg |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Impressions of the Holley Intake. | Skyman | Windsor Power | 19 | 07-02-2002 10:05 AM |
| Road Demon vs. Holley Avenger | Rev | Blue Oval Lounge | 5 | 09-12-2001 08:57 PM |
| Well I did a compression test and it doesn't look goo for my Holley heads... | Rick 91GT | Windsor Power | 6 | 02-20-2001 07:43 AM |
| Holley Heads??? | DemonGT | Windsor Power | 8 | 01-03-2001 09:05 AM |