Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-22-2003, 08:50 AM
|
#1 |
|
Moderator
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
|
Occasionally you will find the thrust too tight with a new set of bearings. When this happens, you simply sand the thrust bearing surface with some 400-600 grit sandpaper on a granite machinists block or good flat machined surface such as a mill table. For a SBF, the thrust should be about 0.004-0.005" with a manual transmission, just slightly less with an auto trans.
__________________
Jeff Chambers 1990 Mustang GT 10.032 Seconds / 137.5 MPH 14-time Street Warrior World Record Setter CRT Performance 2001 Tropic Green Mustang GT - 12.181 / 113.2 MPH 2002 Ford F-250 Crew Cab 7.3l Power Stroke - 17.41@77.2 "There's nothing boring about a small block automatic shifting gears at 9400 rpm!" |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 02:53 PM |
| alternator pulley to crank pully ratio | redrider | Windsor Power | 0 | 12-18-2002 11:43 AM |
| 650HP stock block | ultraflo | Windsor Power | 73 | 11-07-2002 11:35 AM |
| Crank key help "half moon key" | quick89gt | Windsor Power | 2 | 05-05-2002 05:26 PM |
| 69' Steel 302 Crank - Infor anybody? | Shawn | Classic Mustangs | 2 | 08-14-2000 11:09 PM |