Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-25-2003, 01:35 AM
|
#10 |
|
Registered Member
Join Date: Feb 2003
Location: Minturn, CO 81645
Posts: 109
|
My reply
I don't have a vaccum gauge. I don't have a vaccum line going to my MAP. Where should the line be coming from?
I did some electrical tests. Key off disconnected the MAP connector measured voltage between VREF and SIG RTN at vehicle harness connector with map unplugged .8 milli volts Than I did it with KOEO 73 milli volts Then I did PKRWUD's test which involved measurings the MAP/BP SIG a green wire. I left the MAP plugged in and back probed one lead of my DMM on the green wire and my other lead of my DMM went to a freshly sanded ground on the body. 216 milli volts What do you think? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine wiring harness | Dog5ohfun | Windsor Power | 2 | 04-25-2004 11:35 PM |
| New Main Harness M-12071-c302 | Mountain Main | Windsor Power | 10 | 06-18-2003 04:57 AM |
| 88 harness to 90 efi 5.0 harness | UCMEFLY2 | Windsor Power | 0 | 09-10-2002 07:06 PM |
| whats up with this wiring harness? | LX XLR8R | Windsor Power | 3 | 08-17-2001 10:53 AM |
| Underdash Wiring Harness for 68 | Kisner | Classic Mustangs | 3 | 04-28-2001 09:33 PM |