Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-30-2003, 10:32 PM
|
#9 |
|
Registered Member
Join Date: May 2001
Location: Harrisburg, Pennsylvania
Posts: 379
|
ths might be a dumb question ...but if you going off an 89 diagram wouldn't that make it a mass air system
if your running a mass air computer then the map does'nt get hooked up to any vacuum if your running a speed density car the the map should be t'd in to the vacuum at the center of the intake (t it into where your feul pressure reg drawls vacuum)
__________________
the "not so old",old guy 87 Mustang GT T-top >hanlon t-5, pro 5.0, centerforce clutch ,adj. cable/quatrant ,3.27s ,full 2 1/2 ex(off road H) adj. reg. ,e-cam ,70mm TB, cobra intake ,1.7rr ,ported/milled e7ets w/crane springs ,306 balaced/decked short block w/speed pro forged flat top pistons ...257rwhp/302rwt best et 13.7@102 (4/11 ) '80 Capri (future project,currently collecting parts for 351 moter) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W crankcase evacuation | jse9 | Windsor Power | 19 | 09-03-2004 12:00 AM |
| Performer RPM | -RootS- | Windsor Power | 4 | 04-25-2003 06:24 PM |
| Still Misfiring | MidNiteBlu 5.0 | Windsor Power | 17 | 12-02-2002 09:43 PM |
| Need vacuum advise before I start the engine tomarrow-please help | Stang_ROTY | Windsor Power | 12 | 07-23-2001 12:41 PM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |