Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
07-01-2003, 05:07 PM
|
#4 |
|
Registered Member
Join Date: Jan 2002
Location: Dallas
Posts: 24
|
Modular is the design of the short-block to allow for various head/intake setups and configurations to be used on the same basic block. Different heads, however, necessitate different valve covers.
__________________
Lazer Red '98 GT with flows, 3.73's, clear corners, bumper inserts, billet interior, K&N, 17x8 Steeda Ultralites wrapped in Nitto 555's and DR's, Eibach Sportlines, painted calipers, steeda triax , MGW shift knob, 9mm Taylor plug wires, 90mm Lightning mass-air meter, ported FRPP heads, Crane cam regrinds, FRPP intake, FRPP aluminum driveshaft Mac longtubes/off-road H, .20-over bottom end, Vortech S-trim, MSD Dis4 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '87-'93 GT and GT Cobra | Trefty | Windsor Power | 12 | 12-04-2003 05:08 PM |
| Mustang Cobra GT | TransAm86 | Blue Oval Lounge | 4 | 11-26-2002 04:05 PM |
| Is it possible to pass a 96-98 4.6 gt engine off as a cobra somehow?read! | 96_4.6 | Modular Madness | 20 | 11-24-2002 10:20 PM |
| Cobra Engine Swap...Ways to improve my 98 GT... | xtrememach1racer | Modular Madness | 3 | 10-31-2002 11:23 AM |
| Valve covers | rbatson | Windsor Power | 8 | 06-10-2002 11:56 PM |