Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-03-2003, 09:25 AM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: Lynwood, CA, U.S.A.
Posts: 82
|
"remove the 2 upper arm to spring tower attaching nuts and swing the upper arm outward from the spring tower"
The upper arm is held in place by 2 large bolts which you can see from the engine bay right around where the exhaust manifold sits. I'm not sure why Hayne's suggests doing this step, especially since the upper arm shouldn't be in the way if you can just turn it to point toward the floor. I'm wondering which springs you decided to use. If you are using the 620 spring coils, they are approx. 1" lower and they can usually just slide in without having to use the spring compressor.
__________________
65 Mustang Coupe...Comp Cams 262 Xtreme Energy, T-5 conversion, Romac Balancer, 620 Front Springs-4.5 Mid-eye rear springs.......work in progress |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cut front coil springs? | 420nitro | Windsor Power | 13 | 01-26-2004 07:54 PM |
| Are the front or back springs shorter? | Bad89stang | Windsor Power | 2 | 08-05-2002 11:35 AM |
| front springs | greydan | Windsor Power | 3 | 06-27-2002 11:23 PM |
| needing the best front and rear drag springs | Mustangboy89 | Windsor Power | 3 | 09-21-2001 01:30 PM |
| front springs | 69fastback | Classic Mustangs | 1 | 02-26-2001 11:11 PM |