Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-03-2001, 04:11 PM
|
#3 |
|
Registered Member
Join Date: Aug 2000
Location: Phoenix Az. by way of fredericton, NB Canada
Posts: 73
|
Cut and paste, there you go...
Replacement "shorty" headers permitted, must flow through mufflers. Maximum primary tube O.D. is 1 5/8 inch. Maximum exhaust pipe O.D. is 2 1/2 inches. Exhaust exit must run to within six (6) inches of rear axle housing. Side exhaust prohibited. My guess is they would run custom x or h pipes... ------------------ '92 emerald coupe, no air silencer, bored stock MAF to 60mm, sub-frames welded, strut tower brace, 180 thermo, 16 deg's, K'n'N panel, bosh platniums, u.d. pullies, off road h-pipe, hurst "stir stick", fms 3.73's. otherwise, factory original. best 1/4 = 13.264@ 100.89mph with a 1.824 60 ft. on turbines with 235/60-R15 BFG DR's [This message has been edited by cleanLX (edited 08-03-2001).] |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how fast have you guys gone with a stock motor | tireburner163 | Windsor Power | 39 | 01-16-2002 08:09 AM |
| 351W guys..what exhaust??? | LX XLR8R | Windsor Power | 2 | 09-18-2001 12:08 AM |
| 1.7 Roller Rockers, Hand Porting Exhaust Side Of Stock Heads... Good Idea??? | BowTie Eater 5 Liter | Windsor Power | 12 | 09-15-2001 02:00 PM |
| GT40P/ HOT HEAD FOR TROPHY STOCK? | LASH50MUST | Racer's Club House | 4 | 11-03-1999 11:19 PM |
| Trophy stock question | mustang_500hp | Racer's Club House | 2 | 08-30-1999 09:03 PM |