Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-20-2003, 07:52 PM
|
#4 |
|
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
Old Guy...you read my mind. I had already planned that, just in case I fouled out an O2 sensor before the other one...so I could check consistency between both banks. Now the question is, where the hell is the ECM and connector? Never even been near the thing. Is it in the engine bay, or somewhere in the car itself? I heard it was in the passenger side of the car, below the glovebox if I remember right..behind that panel somewhere..?
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn: PKRWUD: Compression Test Results | 95mustanggt | Windsor Power | 13 | 06-22-2004 07:34 AM |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| Boost Gauge Questions | SleeperGT | Power Adders | 3 | 10-01-2003 12:39 PM |
| Boost gauge, need help ASAP!! | Chris_H | Windsor Power | 6 | 05-24-2002 06:07 AM |
| The benefits of a Vacuum Gauge!!! | PKRWUD | Windsor Power | 16 | 07-02-2001 09:12 PM |