Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-26-2003, 07:30 AM
|
#4 |
|
Registered Member
Join Date: May 2000
Location: Kamloops, BC
Posts: 2,875
|
You mean the "bolt" on the pulley? I only needed my short little 3/8" ratchet to get mine off. If an impact won't get it off (Well a good impact, like an IR
 ) you're sol. Don't heat the bolt, it will just expand and make it harded to get out. Try some WD-40 or Liquid wrench. Then try a big impact again, something with 500-700 ft lbs of torque. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem after distributor install | billheis | Windsor Power | 16 | 11-19-2003 11:59 PM |
| Major Problem During Water Pump Install | Evil Joe | Windsor Power | 27 | 07-10-2003 03:45 AM |
| Steeda pully install = oil leak?!! | Rally | Modular Madness | 7 | 04-05-2002 02:58 PM |
| gear install problem | John Cummins | Windsor Power | 2 | 06-10-2001 08:16 PM |
| Transmission install problem | 86StangGT | Windsor Power | 4 | 03-30-2001 06:18 PM |