Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-01-2003, 10:41 PM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: Ottawa illinois
Posts: 41
|
i would get all the gear from a 5speed v8 car. I did mine and it was easy. Youhave to relocate the speenometer cable to left a bit and put the cluch cable through the old speedo hole. any clutch brake assembly will work. U need a v8 flywheel (5speed) and the bolts should work for the bellhousing. The clucth fork should be from a v8. Plate between motor and tranny will be the same as the aod. I got all my stuff from a v8 car so i knew it would work. your aluminum driveshaft will work fine too. If u have any other questions, just pm me
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5 lug conversion | stanger9219 | Windsor Power | 2 | 02-25-2004 11:31 PM |
| What all do you need to do rear disc conversion w/ SN95 Parts | KG88GT | Windsor Power | 1 | 07-29-2003 01:45 PM |
| questions about maf conversion | spankaveli | Windsor Power | 10 | 10-19-2002 02:46 PM |
| 5 to 4 lug conversion | mike_navigator | Blue Oval Lounge | 7 | 08-14-2002 11:17 PM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |