Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-02-2003, 07:30 PM
|
#2 |
|
Registered Member
Join Date: May 2001
Location: Fernandina Beach, FL 32034
Posts: 178
|
Assuming that its the factory Holley, their is ascrew for adjustment it is just hard to get to. you need a short small screwdriver and come in from the front sideat about 4oclock if looking at it from the side. You can take the whole chock assembly off, you just need to block the vacuum port on the side. However you may have problems when the cold weather come back or you could get a manual assembly from Holley to replace it. Go to Holley.com and there is all the info you need to help you
__________________
Bill Heiser 90 Convertable 5.0 LX, ported E7s w/ THumper valve job, TFS street, FR 65mm TB, B cam w/1.7 cobra rockers, kirban AFPR, Mac CAI, Mac Headers, off road h, 3 chamber flows, Crane ign. box, 3:73s, Art Carr AOD & 2600 converter |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carb Woahs | RoadWarrior | Classic Mustangs | 4 | 07-27-2002 11:06 AM |
| efi to carb. /? | WADS56 | Windsor Power | 0 | 09-26-2001 12:45 AM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |
| Demon carb on 289??? | 69roadrunner | Classic Mustangs | 8 | 07-22-2001 09:35 PM |
| demon carb on 289??? | 69roadrunner | Modular Madness | 1 | 07-21-2001 07:42 PM |