Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-05-2003, 05:57 PM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
i would say go get yourself some clay, throw the heads on, and crank her over by hand once or twice. Then check the clay to see if it will clear or not.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| aluminum heads | wht04gt | Modular Madness | 2 | 01-29-2004 01:57 PM |
| pro-topline vs. TFS vs. Edelbrock vs. AFR vs. Canfield heads | ka_dawg98 | Windsor Power | 3 | 12-29-2003 07:53 AM |
| Z304 Aluminum Heads | RSLOOP | Windsor Power | 0 | 12-27-2003 10:41 AM |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| Urgent Help!!!!Just installed aluminum heads on backwards...Will it work OK??? | tb | Windsor Power | 5 | 12-31-2001 12:53 AM |