Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-27-2003, 01:08 PM
|
#2 |
|
Registered Member
Join Date: Oct 2000
Location: Charlotte NC
Posts: 193
|
I've only removed a set of heads one time but I think I remember that when I did remove the heads, a little water got down in the cylinders when the head to block seal was broken. If this is what happened I'd have to say it is normal. If you got alot of water in one of the heads I'd say there's a problem somewhere. Good luck with it.
__________________
1969 fast back; yellow; weld wheels; 302 roller with GT-40 heads; 3:55 gears; 5spd T-5; MSD 6AL; E-303; flows; Hedman headers; Holley 600;Weiand Accelerator;1.6 rockers |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible oil in water?? | Simi Stang | Windsor Power | 1 | 01-24-2003 02:55 PM |
| Free Horsepower, but at what cost?? | 71grande | Classic Mustangs | 13 | 09-21-2002 05:07 PM |
| LOTS of water in exhaust | Stang_Crazy | Windsor Power | 1 | 04-06-2002 02:55 PM |
| Water pump....AC Bracket problem | Jimmy Page | Classic Mustangs | 3 | 07-28-2001 01:54 PM |
| Pulleys, water pump, and fan clutch | dinomite | Windsor Power | 5 | 05-26-2001 09:00 AM |