Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-29-2003, 06:34 PM
|
#6 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
If all else fails, try this... Take the crank pulley off, put two of the four bolts in the dampener on one side, so like two next to each other (on the bottom side would probably be best) then put a big ***** breaker bar on the crank bolt, then wedge your biggest screwdriver under one bolt and over the other so that you can push against the breaker bar with the screw driver (or pry bar i guess) I've done that before, but it's kinda elaborate. goodluck.
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front End Wobble | orlowted | Classic Mustangs | 6 | 04-14-2004 02:23 PM |
| Broke bolt in new head (Kinda Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 05-12-2002 02:00 PM |
| How to remove front bumper? | ciara | Windsor Power | 3 | 03-10-2002 11:38 PM |
| 93 GT broken caliper bolt..help!! | fongo | Windsor Power | 3 | 12-29-2001 07:31 PM |
| Need new front tires... suggestions... | FivepointOH | Windsor Power | 4 | 01-01-2001 11:20 PM |