Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-16-2003, 08:27 PM
|
#8 |
|
Registered Member
Join Date: Oct 2000
Location: ~Columbus~GA~31909~
Posts: 156
|
When you did the swap, did you swap the dash harness also?? If you look behind the driver side strut tower where the engine harness and dash harness connect, how many plugs are there?? The 91 engine harness, should have one(redish) & the 90 haness ahould have 2(blk & gry).. If all this was changed then you have another prob...
Check the ground for the engine harness over by the starter relay. It should have a round plug on it and then a ring to ground it to the body....Also make sure the ground is on by the EEC...
__________________
Mike Blown~AOD'ed~331~ T-top~ 86GT Check out car on my page here ------ > ~~My 86GT T-top ~~ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5 lug conversion problems | gtnby2 | Windsor Power | 4 | 10-08-2004 04:02 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |
| Rear disk brake conversion problems | BLOCKER | Windsor Power | 6 | 04-02-2001 06:10 PM |