Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-20-2003, 12:40 AM
|
#8 |
|
Registered Member
Join Date: Sep 2002
Location: IL
Posts: 105
|
i think that i am going to go with the F303 cam because in a few months i am getting new heads and in about a month i am goin with the edelbrock performer 5.0 intake and i think that the am will match good until then.... because the cam should be great after i do my next mods... any comments? -Thanks!
__________________
89' GT with 5spd Hurst short throw, Keith Black 12:1 comp. pistons, Sealed Power drag racing rings, Fms F303 Cam, Ported and polished upper and lower intake with Ported E7TE heads that contain comp. cam double coiled springs with titainum locks and steel retainers, Fel-Pro Head Gaskets, 9mm ford racing wires, BBK chrome unequal shortys, Power Throttle bodies 70mm, Edlebrock 70mm EGR plate, 15inch K&N, Bassani X-pipe, Flowmaster 40 series, Eibach 1 1/2 lowering springs, Cobra R rims 17X9 with p235 on front and p275 on rear with Falken Zeix tires-RUNNING! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camshaft question.... Please Help! | SmokinStangGT | Windsor Power | 5 | 10-21-2003 06:26 PM |
| camshaft selection | chiaronate | Windsor Power | 2 | 06-09-2003 02:17 AM |
| Camshaft "GURU" needed !!! Cam question. | 5ohCOUPE | Windsor Power | 1 | 03-26-2003 03:39 PM |
| Camshaft question | UglyFast88 | Windsor Power | 6 | 03-04-2003 01:10 AM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |