Does anyone know of a good exhaust coating that actually stays on

[jrgoffin]

The POR-15 stuff is great. I did my long-tube headers, h-pipe, and the tail pipes/flowmasters. It has held up great and looks like jet-hot. If any bits of it get nicked or flake off, you just get out the can and brush it on where you need it. If you don't want to spring for the cost of the jet-hot this is the way to go. I'm about to pick up a set of FlowTech long-tubes and the h-pipe and they will definitely get the POR coating!

I should also add that when I dropped in the new motor, my headers were glowing red while I fiddled around with the timing to get it where it needed to be (me and the timing were both a bit retarded!!). The POR coating flaked in a couple small spots, but that was it. I touched it up and it looks awesome!