MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Classic Mustangs
Reload this Page falcon
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 10-27-2003, 12:00 AM   #4
HotRoddin
cranky old man
 
HotRoddin's Avatar
 
Join Date: Sep 2001
Location: Longview Texas
Posts: 683
Default
Quote:
Originally posted by rtschoneman
will the floor pans cross over??? just looking at the car its very close. what about suspension????????
thanks for the info!
The floor pans no ... the suspension i think most of it. The engine compartment is about an inch and a half wider on the stang so i believe the steering linkage is a little bit different but most of the rest of it is the same.
__________________
Under Construction: 64 Falcon 372 cu in. stroker 1:72 rod ratio 6.250" rods (long rod), Comp Cams XE274 230/236 520/526 @ .050, Scorpion Rollers, Roush 200 irons, 10:1 Keith Blacks, Hedman long tubes, 750 Holley DP, Edelbrock Victor Jr., C4 3500 stall, gears and tires to be anounced.
HotRoddin is offline   Reply With Quote
 

« Previous Thread | Next Thread »


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
falcon engine swap PEPE Windsor Power 5 09-11-2003 08:44 PM
289 in a 61 Falcon? 289 Classic Mustangs 5 03-17-2003 04:49 PM
Ford Falcon AUXR8 race cars Nitrous Al Blue Oval Lounge 2 11-20-2002 07:42 PM
civic vs. falcon vs. 65 fastback tinner Stang Stories 6 01-02-2002 09:22 PM
Installing a 4.6L in a 62 Falcon Futura 62falcon/4.6LCobraConver Small Ponies 0 05-20-1999 06:50 PM


All times are GMT -5. The time now is 07:15 AM.

Archive - Top

SEARCH