Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-27-2003, 05:38 PM
|
#3 |
|
Registered Member
Join Date: Sep 2002
Location: Boston
Posts: 592
|
You're gonna need some wierd socket to get at it since the standard sized ones get stuck in the passage if I remember correctly
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ball joint replace in a 65 - how hard is it? | Steriti | Classic Mustangs | 5 | 07-03-2004 05:32 PM |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Fuel Pump or TFI Module ??? | mimicons | Windsor Power | 1 | 05-13-2003 02:35 AM |
| Is it hard to replace coil springs? Should I pay? | jpumpkinn | Windsor Power | 3 | 06-27-2001 11:46 AM |
| 8" Traction-lock clutches...how hard to replace | Rev | Windsor Power | 2 | 02-11-2001 06:03 PM |