Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-12-2003, 06:13 AM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
not sure about the heads but just check the intake. If the intake has a plastic crossover from the coolant water neck/thermostat area on drivers side to the passanger side it is stock. If the crossover is aluminum they may have upgraded the intake and the heads still might be stock. ALL PI heads have to have the aluminum crossover. More than likely you have stock heads. If they had switched heads your car would be much more moded than it is. The head swap is expensive and usually done by serious motor heads.
Good luck
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help I need heads!! | SmokinStangGT | Windsor Power | 18 | 05-04-2003 10:05 PM |
| New FRP Heads for 96 - 98 4.6 | surfbeast | Modular Madness | 9 | 11-21-2002 07:02 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |