Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-14-2003, 12:28 PM
|
#10 |
|
Registered Member
Join Date: Feb 2001
Posts: 84
|
thanks for the tips guys. I've called the dealer and told him I will bring the car for him to test drive. I'll try the other fixes before i go in. I actually looked at the original 1990 stock disk when it was out and it looked worn, but not terrible. It's all the pressure plate in these new ones that is so wimpy. If I start building up the motor (it's completely stock now) will the extra HP require a stronger pressure plate? One way or the other, I'm getting a different one. thanks again for the tips.
__________________
1990 LX 5.0 Cobra Intake K&N filter ET 15.0 Yokohama ES 100. Cobra R 17's DynoMax SS's Pro 5.0 More to come |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bellhousing clutch pivot setup...? | drudis | Windsor Power | 4 | 01-23-2004 08:13 PM |
| best clutch and setup? | GhettoPop | Windsor Power | 4 | 10-20-2003 10:40 AM |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| How to adjust my clutch | gonnagetagt | Windsor Power | 5 | 03-31-2003 10:08 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |