Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-18-2003, 11:05 PM
|
#3 |
|
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
Hammer - not that I doubt your experience, but I have to disagree with your specific statement.
If you put PI heads w/ NPI cams and a NPI intake on a stock 96-98 bottom end you will not get 30-40HP....Its not happening. In fact, I'd say that 80% of whatever increase you get will be from the increased compression ratio. I know that this dyno is skewed because of the ported heads, but once he dyno's the PI cams and PI intake on a stock 96-98 block, we'll see where the gains come from. And you'll have to remember about the CR on the 96-98 swapped cars. IMHO, the heads themselves are not the power maker that everyone thought they were. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| When replacing heads/ intake | Kamaro Killer | Windsor Power | 3 | 09-23-2002 04:48 PM |
| Heads, Intake | OneBad95 | Windsor Power | 0 | 07-22-2002 12:05 AM |
| Cobra Heads And Intake Swap | surfbeast | Modular Madness | 1 | 03-12-2002 05:41 PM |
| GT-40P heads and intake question | ex-lt1-guy | Windsor Power | 1 | 03-12-2002 09:55 AM |