Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-28-2003, 08:01 PM
|
#7 |
|
Moderator
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
|
Why do that, just take the snap ring out and flip the plunger (right underneath the cup) over and put it back together. That'll make it essentially solid. It's work to get the snap ring back in 'cause the tolerances stack up mighty tight, but it'll go and you'll have a solid lifter. Many folks do this for the entire set to turn hydraulic rollers into solid rollers.
__________________
Jeff Chambers 1990 Mustang GT 10.032 Seconds / 137.5 MPH 14-time Street Warrior World Record Setter CRT Performance 2001 Tropic Green Mustang GT - 12.181 / 113.2 MPH 2002 Ford F-250 Crew Cab 7.3l Power Stroke - 17.41@77.2 "There's nothing boring about a small block automatic shifting gears at 9400 rpm!" |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston to Valve Clearance Check - 351W | Peldor | Classic Mustangs | 4 | 01-31-2008 08:29 PM |
| Checking Valve Clearance | OneBad91 | Windsor Power | 1 | 04-23-2004 10:43 PM |
| AFR 185's w/E-303: Piston to valve clearance problems? | yelowjaket | Windsor Power | 9 | 04-01-2003 07:50 PM |
| Piston to valve clearance - How much do I need? | 2FastLX | Windsor Power | 6 | 03-29-2001 04:54 PM |
| Please - I need advice on piston to valve clearance ASAP | 2FastLX | Windsor Power | 8 | 03-18-2001 03:05 PM |