Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-04-2003, 01:10 PM
|
#2 |
|
Registered Member
Join Date: Jul 2002
Location: Atlanta
Posts: 296
|
Ya...that's just the start. I only had to pay $10 for the speedo gear, but I'm pretty sure the newer stangs need electronic speedo calibrators. Summit had them for $100 las time I looked at them. Installation is where it's going to get you. Pay the money and have it done right. If there are any gaps or a bad install then you will get a winding noise from your rearend. I think I payed around $250 for my install, but I found my gears for $170. I'll look later for the place I found them and post it back up here. It was by far the best deal I found. BTW, I have FRPP 3.73's.
__________________
Current Sophomore -- Mechanical Engineering Black on Black 98' GT 5-Speed Mods = Stuff |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.10s! A scientific study...sort of | xxxBlakexxx | Modular Madness | 5 | 04-09-2004 06:28 PM |
| Speedo gear for 4.10s Anyone?? | Chipdog | Windsor Power | 2 | 04-29-2001 08:32 PM |
| 4.10's vs 3.73's | joey50gt | Windsor Power | 17 | 04-13-2001 04:29 PM |
| Should I swap in 4.10's for my 3.73's- please read | Killercanary | Windsor Power | 15 | 03-27-2001 10:57 PM |
| 4.10's on the street... | STEEDA85GT | Windsor Power | 11 | 03-09-2001 05:58 AM |