

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Registered Member
Join Date: Feb 2003
Location: Oshkosh WI
Posts: 69
|
![]() Sean Hyland Motorsports is where it came from. The FTL3 is most likely the calibration of the ECU it was programmed for. As far as using it on an 88 dont think so. Or less you have switched over to mass air or you actually own an 88 1/2 it wont work for you. Fuel and timing curves are different. As far as harming the motor? The potential is there. SHM calibrates chips to your specific combo. You might be able to find someone who will reflash the chip for you but I think I would first upgrade to Mass air then go from there. Tighter tolerances as far as tuning. Easier to work around when upgrading cams and heads and things like that. http://www.jmschip.com/products/chip-product.html If you read down on that page it states 87-88 on site only. So its possible but easier with Mass Air. I have used them before and actually still have that chip set waiting for someone to use it. Hope this helps.
__________________
93 GT 306 DSS, O-Ringed, AFR 185's, Pro Products Intakes, 55lb low imp inj, 80mm Pro-M meter, 2004 PMS, AFM Power Pipe, Kirban Reg, Vortech S-Trim 14lbs. No times yet. Trying to tune. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Computer chip and ET's | DaTank | Windsor Power | 14 | 04-07-2003 08:53 PM |
Dealer Blew My Computer, Because Of My Chip | WHC3RD | Modular Madness | 1 | 10-20-2002 11:36 AM |
computer question for the gurus | 82 GT | Blue Oval Lounge | 4 | 02-16-2002 07:56 PM |
JMS Chip and 94/95 computer | moponys | Windsor Power | 6 | 09-24-2001 04:33 PM |
Computer Question?? | GhOsT6_9 | Modular Madness | 0 | 03-05-2001 08:16 PM |