Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-16-2003, 06:32 PM
|
#6 |
|
Registered Member
Join Date: Apr 2002
Location: Canada
Posts: 58
|
A 90' truck block will work fine. If you can find a 95' block they are machined to accept any 5.0L roller cam. If you use a older block you can get a retrofit roller cam from Crane or Comp Cams. Or you can use any 5.0L cam with link-bar roller lifters.
__________________
351W .030", AFR 185s, Crane roller cam-.543" 220 -.562" 228@.050, TFS 351W EFI intake, Billet Roller Rockers, BBK Long Tubes, BBK X- Pipe, Dynomax Race Magnums w/dumps, 30lb injectors, 190lph intank pump, Holley Adjustable FPR, 75mm TB&MA, Underdrive pulleys, Aluminum Rad, Billet Flywheel, McCloud Clutch, World Class T-5, B&M Ripper Shifter 4.10s, McCreary G-60s, Lakewood 90/10s, Comp. Enginering 3 way adjust/rear, Upper and Lower Control arms, Autometer gauges. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| 2001 Painted White Interior Pieces | steedamustang01 | Modular Madness | 10 | 09-05-2002 11:09 AM |
| What's needed to build a Turbo 5.0L? | Gautam | Windsor Power | 1 | 06-07-2001 05:34 PM |
| what credentials are needed to compete? | Beni | Racer's Club House | 2 | 04-05-2000 08:13 AM |