Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-31-2003, 05:09 PM
|
#1 |
|
Registered Member
Join Date: Nov 2003
Location: Rockford
Posts: 596
|
If you think your engine is wearing a little to fast then perform the following tests.
1) Compression test. There should be no more then a 5% difference between the cylinders. I would expect 135-170 psi for your set-up. 2) Cylinder Leak Down Test. Should be no more then 12%. The less the leak down, the better. Not to say that 12% is bad but thats about the most I would like to see. Mine is at 0-2%. It is also possiable the the difference in air and traction played a role in you MPH. I would also agree that you are running a little to much fuel pressure. I would say 36-38 psi with NO vacuum signal. Good Luck |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Track conditions | Eric4Nitrous | Windsor Power | 12 | 11-22-2002 10:59 PM |
| Modded Vette goes down (Fun night at track) | Hammer | Stang Stories | 5 | 12-11-2001 02:04 AM |
| Tell me what you think...track numbers | silver_pilate | Blue Oval Lounge | 5 | 10-30-2001 03:44 PM |
| Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track | KB1991 | Ford Show & Go | 0 | 05-03-2001 12:33 PM |
| Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track | KB1991 | Corner Carvers Delight | 0 | 05-03-2001 12:32 PM |