Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-07-2004, 11:47 AM
|
#3 |
|
Registered Member
Join Date: Feb 2003
Location: Oshkosh WI
Posts: 69
|
Just wondering if you are getting all of the avail. amperage to the starter. Yes it is possible for the starter to be bad. There should be a starter solenoid on the fender near the battery somewhere. If you are feeling risky jump a screwdriver between the two large cables to bypass that. If that doesnt work then point to the starter. If its not too bad to remove just take it out and take it to a parts store and they should be able to test it for free. -25? Is that with the wind chill? I hope so because it was -5 here last night and that was cold. Hope this helps.
Brad
__________________
93 GT 306 DSS, O-Ringed, AFR 185's, Pro Products Intakes, 55lb low imp inj, 80mm Pro-M meter, 2004 PMS, AFM Power Pipe, Kirban Reg, Vortech S-Trim 14lbs. No times yet. Trying to tune. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| hard starting | JMG | Small Ponies | 2 | 01-22-2006 12:09 PM |
| '94 Ford Bronco starting problems | Simi Stang | Built Ford Tough | 5 | 01-17-2003 08:53 PM |
| Please Help !! Engine Starting Problem | Jayskee | Windsor Power | 1 | 07-23-2002 06:08 PM |
| starting problems | 92Convertible | Windsor Power | 1 | 03-10-2002 06:22 PM |
| Good night at the track, but idiots wet down starting line | Rev | Stang Stories | 7 | 02-11-2001 06:39 PM |