Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-18-2001, 03:31 PM
|
#3 |
|
Registered Member
Join Date: Oct 1999
Location: Cincinnati, Ohio
Posts: 1,575
|
Either try rotating the drive shaft 180 degrees, and if that doesn't take care of it an Aluminuim one usually does.
------------------ 87 GT, Cobra R's,GT-40 heads,Crane 2031,1.7's, Edelbrock intake, long tubes,BBK cold air, Mass air,pulleys,Pro 5.0, King Cobra,Lakewood Lift Bars,50/50's,subframes, 4.10's. Best time 12.759 Best MPH 106.79 Best 60' 1.695 Visit my site at: http://www.geocities.com/cobrar93_2000/MyPage.html |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need gear installation - Missouri! | stock89 | Windsor Power | 0 | 02-20-2003 04:37 PM |
| speedometer gear installation? | squid | Windsor Power | 2 | 12-12-2002 12:42 AM |
| ring and pinion gear installation | chiaronate | Windsor Power | 5 | 11-05-2002 07:47 PM |
| Gear installation kit? | TwiLighTBluEGT | Windsor Power | 0 | 07-19-2002 01:38 PM |
| Gear Installation in Dallas Area | 95mustanggt | Windsor Power | 3 | 01-23-2002 10:50 AM |