Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-30-2004, 06:49 PM
|
#2 |
|
Registered Member
Join Date: Sep 2003
Location: Orange, TX
Posts: 360
|
Not sure about door molding but you can remove the pony emblem with a hair drier. It is put on with hot melt glue. Might try heating it up a bit with a hair drier and see if you can pull it off.
__________________
2003 3.8 Mineral Gray, MAC CAI, K&N, Chin Spoiler |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to remove belt tensionner pulley (picture inside) | White GT | Windsor Power | 5 | 06-18-2004 06:37 AM |
| remove hunk of metal near rear pumpkin? | Simi Stang | Windsor Power | 2 | 12-05-2002 06:27 PM |
| A/C Delete....Can I remove the condenser & the accumulator?? | MTU 50 | Windsor Power | 15 | 06-24-2001 12:26 AM |
| What type of screw to remove seatbelt? | Gautam | Blue Oval Lounge | 3 | 01-26-2001 04:48 PM |
| How to remove door panel in '89 5.0L? | Gautam | Windsor Power | 1 | 01-12-2001 03:14 PM |