Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-02-2004, 04:05 PM
|
#3 |
|
Registered Member
Join Date: Nov 2003
Location: Collinsville, IL
Posts: 46
|
my opinion
I had to take my molding off when I painted my car, and we just used something to pry underneath it like a putty knife and there is two sided tape holding it on. It comes off in in a strip but the only thing is when putting them back on (with two sided tape) make sure to get it tight and as straight as possible. If not they tend to look wavey along the door, because of being stretched when pulled off. Your best bet really would be to buy new ones, they cost about $125 each. There will be left over junk stuck on the door too, that can be taken down with a d/a or a buffer.
__________________
1990 mustang LX hatch 5.0 holly upper/lower intake, timing chains, F303 cam, 24lb fuel injectors, 75mm mass air meter, underdrive pulleys, 3:73 gears, BBK C.A.I., BBK long tube headers, Off road H-pipe, 17" cobra R's, 2800 stall yet to come....... |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to remove belt tensionner pulley (picture inside) | White GT | Windsor Power | 5 | 06-18-2004 06:37 AM |
| remove hunk of metal near rear pumpkin? | Simi Stang | Windsor Power | 2 | 12-05-2002 06:27 PM |
| A/C Delete....Can I remove the condenser & the accumulator?? | MTU 50 | Windsor Power | 15 | 06-24-2001 12:26 AM |
| What type of screw to remove seatbelt? | Gautam | Blue Oval Lounge | 3 | 01-26-2001 04:48 PM |
| How to remove door panel in '89 5.0L? | Gautam | Windsor Power | 1 | 01-12-2001 03:14 PM |