Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-17-2004, 03:01 AM
|
#5 |
|
Registered Member
Join Date: Feb 2003
Location: Oshkosh WI
Posts: 69
|
Are there two dials on it with ports to plug in a DVOM? If so one dial should be idle and the other high speed. You will need to know Air/Fuel ratio or be able to measure Exhaust Gas Temp to be able to fine tune it. But you should be able to lean it out far enough to make it run. Obviously you will need to adjust it down as far as it will go if you are running that rich at idle.
__________________
93 GT 306 DSS, O-Ringed, AFR 185's, Pro Products Intakes, 55lb low imp inj, 80mm Pro-M meter, 2004 PMS, AFM Power Pipe, Kirban Reg, Vortech S-Trim 14lbs. No times yet. Trying to tune. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pro M Optimizer Experience Needed | Mustvid | Windsor Power | 1 | 10-04-2004 03:17 PM |
| remote turn on lead | spydar336 | Audio, Security, & Electronics | 1 | 12-21-2003 09:20 PM |
| Pro M remote Optimizer? | Saleen367 | Windsor Power | 3 | 08-10-2001 01:03 AM |
| Remote Battery Cut off Switch | 1988GTCONERTIBLE | Windsor Power | 3 | 06-07-2001 07:19 PM |
| Tokico Illumina 5-Way Adj. Remote adjuster | CO Stang | Classic Mustangs | 1 | 03-13-2001 06:30 PM |