Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-23-2001, 10:32 AM
|
#1 |
|
Registered Member
Join Date: Aug 1999
Location: Fairfax, VA
Posts: 220
|
I replaced my fronts about a mont ago...I had 75K on the original bearings so I went ahead and replaced them (as I had bought new rotors too). To pack the bearings, put a glob of grease in the palm of your hand and keep working grease up until it comes out the top - you don't want ANY air bubbles/pockets! As far as tightening the retaining nut - I put it on just over hand-tight while holding the nut in a socket (for better grip) - then backed it off a little for the cotter pin to fit.
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear brake blocks before front break | nielsmobers | Classic Mustangs | 3 | 10-06-2003 02:26 PM |
| Help! More brake questions | Kisner | Classic Mustangs | 6 | 03-16-2002 11:00 PM |
| Will 99+ wheels fit the Mustang 5-Lug, 11" Front Brake Rotor Conversion Kit ??? | fantozi | Windsor Power | 1 | 08-13-2001 03:27 PM |
| Front Parking Brake Cable | Kisner | Classic Mustangs | 0 | 07-26-2001 10:06 AM |
| SS front brake lines for M2300K | drudis | Corner Carvers Delight | 1 | 04-11-2001 12:57 PM |