Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-20-2004, 03:57 PM
|
#6 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
Clarification
Actually, I was not asking whether or not to re-use those gaskets.
I guess I should clarify for the reading impaired. I was asking if that poor seal around number 5 was enough to cause the oil consumption problem I was observing. Pulling oil vapor from the windage tray/lifter valley is a sketchy diagnosis. If it wasn't, I was going to pull the cylinder head while I had the intake off. Otherwise, I was going to stop at the intake and try a new gasket and go with it. Anyway, it is back together with some 1262's. The builder put 1250's on it originally and I think that was part of the problem.
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LOWER INTAKE GASKET | red90lx | Windsor Power | 0 | 03-20-2001 11:30 AM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Fel-Pro 1250 gasket match to E7 intake ports ??? | cojonepony | Windsor Power | 1 | 01-31-2001 04:57 AM |
| New MAC intake? | gt93mustang | Windsor Power | 19 | 01-22-2001 03:33 PM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |