Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-23-2004, 01:27 AM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Arlington, Washington
Posts: 92
|
I got the taylor wiring kit with the aluminum box. You will need about 20ft of positive wire to reach the starter selenoid. I am using 1/0 guage left over from my stereo days. The ground wire I used is 4 gauge and I ran it through the rubber grommet on the passenger side of the floor at the front of the floor, in the hatch area. I then grounded it by the quad shock to the rear frame rail. Hope this helps.
__________________
Black 1990 LX DSS Racing Super Pro Bullit 331, AFR 185, Anderson B31 Cam, 1.6 DSS rockers, Cobra Intake w/ 2 phenolic spacer, Aluminum DS, 3.73 gears, Tremec 3550, Lakewood SFI Bellhousing, MSD Digital 6+, Spintech Side Exhaust, |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Battery..Solenoid..Starter problem | abesmith69 | Windsor Power | 6 | 04-09-2003 09:39 AM |
| Battery Disconnect and ECM Reset | mimicons | Windsor Power | 1 | 02-18-2003 11:20 AM |
| Battery is dead after pulley install?!? | Stang_Crazy | Windsor Power | 16 | 02-07-2002 09:39 PM |
| Battery not charging | Mustang_289 | Windsor Power | 8 | 01-04-2002 07:07 AM |
| battery removal | 82 GT | Windsor Power | 2 | 03-18-2001 04:40 PM |