Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-23-2004, 08:47 AM
|
#12 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
1262's
I actually put new 1262's in, that's what TFS calls for and they matched up well. Just had to do some minor trimming around the water ports. Permatex Ultra Black is also what they call for around the water ports and front and rear in lieu of the gasket.
The consensus is that the oil has to be coming from "up top" and that it isn't a bad ring. It is just the way oil is rather quickly evenly distributed over a brand new plug in just a few minutes of operation at idle, still no smoke ever. Going to pull the valve cover, check guides and install new umbrella seals just to see if that is it.
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LOWER INTAKE GASKET | red90lx | Windsor Power | 0 | 03-20-2001 11:30 AM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Fel-Pro 1250 gasket match to E7 intake ports ??? | cojonepony | Windsor Power | 1 | 01-31-2001 04:57 AM |
| New MAC intake? | gt93mustang | Windsor Power | 19 | 01-22-2001 03:33 PM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |