Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-24-2004, 06:49 PM
|
#5 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
Did you plastigage the clearances when you were installing the crank? When I had my crank ground I still made sure the bearings going in were the right size before it was too late (they were within specs on the tighter side which was good), but I wasn't about to trust the guy who helped me load up my block/parts at the machine shop. I'd look into the pump and even the oil pressure sending unit, you could always buy one and try it, then if it doesn't change anything then return it.
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil Pressure Very low on new setup!!! | Z28EATR | Windsor Power | 17 | 09-16-2003 04:03 PM |
| Fuel pressure question - HELP! | Stang_ROTY | Windsor Power | 30 | 05-30-2003 08:20 AM |
| Rising Fuel Pressure with Rising RPM? | StreetStang37 | Windsor Power | 1 | 05-21-2002 03:49 AM |
| Please Help...Fuel pressure keeps moving. | Dark_5.0 | Windsor Power | 2 | 04-06-2002 01:31 AM |
| fuel pressure and bad injectors??? | wrathchild | Windsor Power | 1 | 10-02-2001 06:40 AM |