Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-03-2004, 12:41 PM
|
#2 |
|
Registered Member
Join Date: Sep 2003
Location: st. louis, MO
Posts: 197
|
Its not hard at all...just drill out the rivets, pop of the little things holding the handle in, and put the new one in with nuts and bolts. I just put new ones on both sides cause the old ones looked like crap. Hope that helps, but the job is pretty basic.
__________________
98 Cobra, CAI, Flowmasters, o/r h-pipe. 4.10s, Hurst shifter. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ball joint replace in a 65 - how hard is it? | Steriti | Classic Mustangs | 5 | 07-03-2004 05:32 PM |
| T5 hard to shift after replacing bearing retainer | Merlin76 | Windsor Power | 8 | 02-20-2004 10:22 PM |
| replacing side view mirror...how hard? | 82 GT | Windsor Power | 2 | 02-11-2004 11:31 PM |
| replacing hard brake lines | 82 GT | Windsor Power | 0 | 05-26-2002 02:57 PM |
| Replacing convertible top. How hard is it? | Dark_5.0 | Windsor Power | 7 | 06-09-2001 09:01 PM |