Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-03-2004, 06:09 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: Edison, NJ, USA
Posts: 125
|
I did the same for my drivers side handle a few weeks ago, I ordered the heavy duty rivet gun, door handle and rivet set from 50resto.com. The gun was $25, real easy to use.
If you get the gun, don't lean into the gun after the second pump of the handles...when the rivet finally pops the gun jumps back and if you are leaning into it you'll wind up scratching the paint. Take care, Rich D. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ball joint replace in a 65 - how hard is it? | Steriti | Classic Mustangs | 5 | 07-03-2004 05:32 PM |
| T5 hard to shift after replacing bearing retainer | Merlin76 | Windsor Power | 8 | 02-20-2004 10:22 PM |
| replacing side view mirror...how hard? | 82 GT | Windsor Power | 2 | 02-11-2004 11:31 PM |
| replacing hard brake lines | 82 GT | Windsor Power | 0 | 05-26-2002 02:57 PM |
| Replacing convertible top. How hard is it? | Dark_5.0 | Windsor Power | 7 | 06-09-2001 09:01 PM |