Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-11-2004, 11:55 AM
|
#8 |
|
Gimme a Drink!
Join Date: Dec 2002
Location: NYC
Posts: 694
|
about to install my 3 electric gauges, water temp, oil pres, and volts. first, i hooked up the (+) and (-) wires for the gauge's lights directly to the ignition and ground terminals on the gauges themselves. i dont care if the lights are always on and its less wires to run. now, i hooked up all three ignition terminals in series w/ 18 gauge wire then ran a 14 gauge wire w/ 10 amp inline fuse to power all three gauges. its less wires to run this way. where is the best connection, stater solenoid? will volt gauge be accurate? i also did the same for the ground connections.will this work?
i also am not gonna reconnect my stock gauges. will dead stock gauges cause any code/dummy light issues or problems?
__________________
1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| Just an FYI on AutoMeter Mechanical Water Temp Gauge Install | RED92LX50 | Windsor Power | 15 | 05-06-2003 08:12 PM |
| How do I install an Autometer gauge | Kamaro Killer | Windsor Power | 1 | 09-16-2002 06:36 PM |
| Autometer electric FP gauge install question | Mike Souslin | Windsor Power | 0 | 06-24-2002 05:44 PM |
| Gauge Install Questions | RB92GT | Windsor Power | 3 | 06-09-2001 03:07 PM |