Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-23-2001, 09:05 PM
|
#2 |
|
Registered Member
Join Date: Mar 2001
Location: Southern Maryland
Posts: 471
|
It probably uses a "Roll Pin". That's a case hardened round pin with a split down the length, so when you drive it in the hole, it will close the split and friction will hold it in.
Measure the length, and diameter of the hole. You can get these at most real auto parts stores, Home Depot has them and I believe Lowe's also stocks them. At Home Depot, they are in the nut and bolt section. Make sure it's (the pin) just a little larger than the hole. You should have to drive it in with a hammer. ------------------ '89 LX 5.0 - 5 speed. Original Owner '94 E-150 4.9 Conversion Van |
|
|
|
|