Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-13-2004, 08:21 AM
|
#1 |
|
Registered Member
Join Date: Nov 2000
Posts: 290
|
O.K. I bought a grease gun and multi-purpose grease cartridges at AutoZone. However, when I greased all the fittings (did find the one on the U-Joint which I never knew was there) I'm under the impression or illusion that no grease went in. It just seemed to squeeze out around the zerk fittings when I pulled the trigger. It did this on all the fittings. I held it straight and tight up against the fittings. Am I doing something wrong? Do you have to unscrew these fittings like a brake bleeding screw to get them to open up? Or is it possible they were all already filled with grease? Also didn't seem like the zerk fittings went far enough down into the end of the grease gun. I'm stumped.
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another tire question | 96Saleen | Modular Madness | 6 | 02-10-2004 05:27 PM |
| A stupid question I hate asking about exhaust sound | jwboner | Windsor Power | 4 | 08-05-2003 05:55 PM |
| dielectric grease vs white grease | BilLster | Windsor Power | 1 | 05-17-2003 04:50 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Newby here, I have a question on Odometers | mustangmama | Blue Oval Lounge | 3 | 03-03-2001 06:43 AM |