Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2004, 02:34 AM
|
#4 |
|
The Redneck James Bond
Join Date: Sep 2000
Location: Fayetteville NC
Posts: 1,707
|
I got a set of Comp Cams. Easy to install, but then again, I had the whole engine out of the car, and it was a totally new block and everything.
The Comp Cams 102600 may say Noticable idle, but it lopes pretty damn good. Its a little misleading there description.
__________________
64 1/2 "D" code Red Mustang Coupe. Red Baron, 2000 Perf Red Mustang GT. 5spd. Stage 2 CNC heads with Large Valves, Comp Cams (270-274 dur .550 lift), Forged Crank, DRP pistons, Manly H-beams, Pro M 87 mm Mass Air, 24lb Inj, 75mm TB, Plenum Spacer ,Long Tube Headers, Homemade H-pipe, 2 chamber Flows, 4:10's, Steeda Tri-Ax, LKW 70/30's, Eibach Drag Springs, Steeda SubFrames, Battle Boxes, Rear Girdle, Adj uppers, Alunimum Drshft, Southside Lift Bars. Project Cars, 64 1/2 6cyl coupe, 1930 Model A Nostalgia Rod. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aftermarket Mod Cams | SLOW 97 | Modular Madness | 15 | 03-20-2002 09:53 AM |
| how can you tell apart 99 heads and cams and 98 heads and cams | 98 NosStang | Modular Madness | 5 | 09-25-2001 11:51 PM |
| crane cams survey | BurninBurt | Modular Madness | 0 | 06-05-2001 11:47 AM |
| Question on CAMS for my 4.6L...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 07:12 PM |
| Question concerning HEADS and CAMS...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 02:16 AM |