Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2004, 03:31 AM
|
#8 |
|
Registered Member
Join Date: Jul 2003
Location: Sebastopol CA
Posts: 169
|
Merc...
did they give you good power gain through out the whole rpm range and not just high rpms?? Thanks! I want to cam mine but I'm looking at the 102200... 1600-5600rpm 268 274 @ .50 wonder if its about the same rough idle? anyone know what the stock 2v cam specs are???
__________________
Torch Red '02 GT Convertible 5 spd BBK long tubes, BBK h-pipe, MAC mufflers, K&N w/ silencer trimmed, FRPP 70mm throttle body, C&L plenum, Mobil1 synthetic fluids, FRPP aluminum drive shaft, Steeda Tri-Ax shifter, FRPP 4.10's, 18x9 & 18x10 Saleens with Dunlop SP Super Sport Race rubber, Mach1 grill (GT delete), & Mach1 bumper chin! Click here for pictures & more info! If you are in Northern California, check out North Bay Mustang Club for local meets and cruises! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aftermarket Mod Cams | SLOW 97 | Modular Madness | 15 | 03-20-2002 09:53 AM |
| how can you tell apart 99 heads and cams and 98 heads and cams | 98 NosStang | Modular Madness | 5 | 09-25-2001 11:51 PM |
| crane cams survey | BurninBurt | Modular Madness | 0 | 06-05-2001 11:47 AM |
| Question on CAMS for my 4.6L...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 07:12 PM |
| Question concerning HEADS and CAMS...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 02:16 AM |