Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2004, 08:44 PM
|
#17 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
JBeryleC,
Think about this. You say that the intake spacer seems worth it at $70 for a 2rwhp gain (if you even get that). But you said the Kenne Belle 6psi non-intercooled twin screw was expensive for a 106rwhp gain. That comes to almost exactly the same $/hp. I realize that not everyone has the money to buy a blower, but don't waste yours on a spacer. If anything just buy an upper plenum for between $100-200 that actually gives you a proven gain and is optimized without a spacer.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EGR Spacer | brannus | Windsor Power | 7 | 04-23-2003 07:01 PM |
| steeda 18 cam help need more info | FordFasteR | Windsor Power | 4 | 03-28-2002 01:10 PM |
| carb spacer | hippi97 | Racer's Club House | 4 | 08-11-2001 12:10 PM |
| AAAARGH! Steeda timing adjuster causing computer problems!!! | bark3rd | Modular Madness | 1 | 06-04-2001 08:15 PM |
| Timing adjustment with Steeda adjuster | bark3rd | Modular Madness | 5 | 05-17-2001 07:12 AM |